Introduction¶

When DeepSeek Harness (DSH) runs tasks locally, the results usually remain only on the screen. This plugin turns the conclusion of each round into a service card and pushes it to the negative one-screen of a Huawei phone (Intelligent Assistant · Today). If you are away from your computer, take out your phone, tap the card, and you can see the full content. The plugin is compatible with dsh 0.1.5 / cordis 4.

Installation and Configuration¶

Installation and configuration can be done in two ways: command-line installation or configuration file modification.

Command-Line Installation¶

Run the following command to install the plugin:

dsh plugin --profile web add dsh-harmonyos-hiboard

After installation, dsh must be restarted for the change to take effect. After restarting, go to the plugin panel and enter the authorization code. Obtain the authorization code on your phone: negative one-screen -> Me -> Dynamic Management -> Associated Accounts -> Claw Agent.

Configuration File Method¶

Edit ~/.dsh/profiles/web/cordis.patch.yml and add the configuration item:

- id: hiboard-push
  config:
    authCode: <你的授权码>

Core Features¶

Rendering Capabilities¶

The plugin supports complete Markdown content rendering, including tables.

Provided Tools¶

The plugin provides three tool commands:
* hiboard_push: Push a card.
* hiboard_verify: Verify.
* hiboard_push_selfcheck: Self-check.

Fallback Mechanism¶

The plugin has a three-level fallback mechanism to prevent silent card loss.

Notes¶

• The authorization code is a personal credential; if it is leaked, a new code must be obtained on the phone.
• “Every round must be pushed” is a heuristic rule, not a hard guarantee.
• Version upgrades require restarting dsh to take effect.
• The plugin’s configuration read/write route /hiboard-push/config does not inherit dsh authentication; separate authentication is required.
• Card descriptions do not switch with language.